StewMac 4mm Allen Nut Hot Rod Truss Rod

4mm Allen Nut Hot Rod Truss Rod

A smaller 4mm (5/32") Allen nut for most instruments. Smooth two-way action corrects upbow and backbow, giving complete control over the neck.

Easy to install. The Hot Rod® fits in a straight channel. For proper operation, this truss rod must be installed so that the active rod (the rod with the adjustment nut) is below the passive rod. A wooden filler stick is not required.

Smooth 2-way action with superior strength for stubborn necks.
Our Hot Rod neck adjustment system features twin rods in threaded brass collars. The stainless steel active rod turns forsmooth neck alignment, with 2-way action to correct upbow and backbow.

The Hot Rod requires an access cavity for the adjustment nut, and a straight 7/32"-wide x 7/16"-deep slot (measured from the bottom of the fretboard) for installation.

Pick the Hot Rod Truss Rod size you'll need:
(overall length includes the nut)

We've designed the Router Bit for Hot Rod Truss Rods especially for routing your neck to fit our truss rods.

Hot Rod® is a registered trademark of Stewart-MacDonald Manufacturing Company, Inc.