Special bit for templates! Extra-long carbide-tipped router bit produces clean, precise body cavities when used with routing templates.
The ball-bearing guide matches the cutting diameter, and the long shank allows multiple-pass routing for deep cavities.
The 3/8" cutter is recommended only for routing corners that need the tighter radius, and it comes with 2 bearings.
Shank diameter: 1/4" (6.35mm)
Cutting height: 1/2" (12.7mm)
A heat-resistant sleeve (not shown) holds the bearing in position. We recommend stacking an extra bearing on the shank for deep cavities, and using this 3/8" bit only for routing corners.
Tip: We recommend that you change the position of stacked bearings on the router bit's shank every time your re-chuck in the bit into your router. This will greatly extend the life of the bearings and reduces the risk of a bearing "blow-out."
|Name||StewMac Ball Bearing Router Bits, Router bit, 3/8" dia.|
|Air shipping allowed||Yes|